Is it possible to have a clean energy of the rain? Scientists generate electricity from drops
propagandaThe rain may one day become In a clean electricity source, according to a group of Singapore scholars. You have achieved your experiences Energy generation from water drops That falls through a tube. They say this may be a model to take advantage of greater amounts of electricity from the fall that decreases.
Electricity generation from rain drops
Researchers from the National University of Singapore They used rain drops that fall through a tube to generate enough energy to operate 12 diodes. Its method depends on the principle that when two materials are connected, the entities loaded with their surfaces receive a small boost, such as when the balloon is rubbed on the skin and Fixed electricity is created.
Likewise, the flow of water on some surfaces can gain or lose pregnancy. “Water, which is located through the vertical tube, is born a large amount From electricity using a specific pattern of water flow: flow cover, “Siowling Soh, author of the study published in the Central ACS magazine for science.” The flow pattern in this cover can allow the generation of rain energy to generate Clean and renewable electricity“.
Rain energy: What is the pregnancy semester?
The current water is already used to generate it electricity Stir the turbine, but this is limited to places with large amounts of water, such as rivers. The researchers claim to benefit from The download chapter is a solution For smaller and slow sizes. This phenomenon produces electrical shipments when the water moves through a channel with an internal surface connected to electricity.
However, the pregnancy separation can be very ineffective because the area that Energy can be harvested It is limited to the surface where the water moves. To improve performance, the team designed a simple group that went through water Lower a tower through a needle Metal and throw drops of rain when opening a tube.
The front clash of the drops at the top of the tube causes the flow of ingredients: short water columns interspersed with air bags. When the water flowed inside the tube, electrical charges were separated. After that, the water was collected in a bowl under the tube. The cables placed in the top of the tube and in the cup are collected electricity.
Rain energy collector on your roof?
About the component flow system more than 10 % of the water energy that fell through the tubes. Since the speed of the tested drops were much lower than the speed of the rain, researchers indicate that the system can be used to harvest more electricity From the rain that falls.
They say that the ingredient power can be easier to install And maintenance that hydroelectric plants can be convenient for urban spaces such as surfaces.
